Cleaning And Disinfecting - Permobil ROHO Hybrid Elite Manual De Operación

Cleaning and Disinfecting

Cover Care
For cover care instructions, refer to the manual provided with the cover.
Cushion Care
Warnings:
- DO NOT machine wash or machine dry the contoured foam base or the foam insert. DO NOT machine dry the cushion insert.
- DO NOT allow water or cleaning solution to enter the cushion. Make sure the inflation valve(s) are closed. Hybrid Elite SR: Make sure the Smart Check is
detached from the cushion. Water in a cushion with Sensor Ready (SR) technology can result in damage to the Smart Check and cause a false reading when
using Smart Check.
- Cleaning and disinfecting are separate processes. Cleaning must precede disinfection. If the product becomes soiled, or between use by different individuals:
clean, disinfect, and check the product for proper functioning.
- Clean the product regularly and when it becomes soiled.
- Follow all manufacturer bleach container and germicidal disinfectant safety guidelines.
- Note about sterilization: High temperatures accelerate aging and will damage the product assembly. The products featured in this manual are not packaged
in a sterile condition, nor are they intended or required to be sterilized prior to use. If institution protocol demands sterilization: First, follow the cleaning and
disinfecting instructions; then, open the inflation valve(s) and use the lowest possible sterilizing temperature, but not to exceed 70°C (158°F), for the shortest
time possible. DO NOT autoclave.
Cautions:
- Use of the following may cause damage to the cushion: abrasives (steel wool, scouring pads); caustic, automatic dishwasher detergents; cleaning products
that contain petroleum or organic solvents, including acetone, toluene, Methyl Ethyl Ketone (MEK), naphtha, dry cleaning fluid, adhesive remover; oil-based
lotions, lanolin, ozone gas; ultraviolet light cleaning methods.
- DO NOT expose to direct sunlight.
Recommendation: When washing by hand, use room-temperature water.
Note: Deflated air cells may be easier to thoroughly clean. To deflate the air cells: with the inflation valve(s) open, roll up and/or compress the cushion, and then
completely close the inflation valve(s).
Hand Wash and Disinfect the Cushion Insert (Preferred Method)
Carefully remove the cushion insert from the contoured foam base. Close the inflation valve(s). Hand wash, using mild liquid hand soap,
hand dishwashing liquid, laundry detergent, or a multipurpose detergent (Follow product label instructions.) Gently scrub all cushion
surfaces, using a soft plastic bristle brush, a sponge or a cloth. Rinse with clean water. Air dry.
To disinfect, repeat cleaning instructions, using 1 part household liquid bleach per 9 parts water. Keep the product wet with the bleach
solution for 10 minutes. Rinse thoroughly with clean water. Air dry.
Caution: Rinse thoroughly. Detergent residue may cause air cells to stick together.
Clean and Disinfect the Contoured Foam Base and Foam Insert
To clean and disinfect the Contoured Foam Base: Remove the cover, foam insert and cushion insert. To clean, wipe gently
with a cloth dampened with water and a household detergent, then rinse with cool, clean water.
To disinfect, follow the cleaning instructions, but use disinfectant instead of household detergent. After cleaning or
disinfecting, allow the foam to air dry thoroughly before putting the cover on.
To clean and disinfect the Foam Insert: To clean, moisten a cloth, then wring to remove excess water. Wipe gently with the
cloth and a household detergent, then wipe again with a clean, slightly damp cloth.
To disinfect, follow the cleaning instructions, but use disinfectant instead of household detergent. After cleaning or disinfecting,
allow the foam to air dry thoroughly before putting the cover on.
ROHO Hybrid Elite Cushion Operation Manual
7
+
1:9