Troubleshooting - Permobil ROHO Hybrid Elite Manual De Operación

Foam Insert Removal and Replacement, continued
Foam Insert Replacement
Warning: The foam insert must be correctly positioned on the contoured foam base.
Note: If the cushion insert was removed from the contoured foam base, replace the cushion insert before replacing the
foam insert. See "Cushion Insert Replacement".
1 Position the foam insert on the contoured foam base.
- The foam insert should be next to the air cells (A). Make sure the foam insert is not on top of the air cells.
- The foam insert should line up with the front edge of the foam base (B). Make sure the foam insert does not extend
past the front edge of the foam base.
- The foam insert should be centered on the foam base.
2 Once correctly positioned, press down on the foam insert to securely attach it to the contoured foam base.
3 Slide the tubing through the loop on the foam insert. As needed, push the tubing back into the groove. Repeat for
other side.
4 Flip the cushion over so that the cells face down and the bottom of the contoured foam base faces up.
5 Pull and attach the foam insert flaps to the hook fastener pieces on the bottom of the contoured foam base.
6 Flip the cushion over so that the cells face up and the bottom of the contoured foam base faces down.
7 Replace the cover. Refer to the instructions provided with the cover and to the "Cover Removal and Replacement"
section in this manual.

Troubleshooting

For additional assistance, contact your equipment provider, distributor, or Customer Support.
The cushion is not holding air.
Not able to inflate or deflate the
cushion.
The cushion is uncomfortable
or unstable.
The cushion slides on the
wheelchair.
A component is damaged.
ROHO Hybrid Elite Cushion Operation Manual
Inflate the cushion. Inspect for damage to inflation valve(s), hose(s) and the quick disconnect (Hybrid Elite SR). Confirm
that the inflation valve(s) are completely closed. Look for holes in the cushion. If very small holes or no holes are visible,
follow the instructions in the Repair Kit provided with your product. For damage to the inflation valve(s), hose(s), or quick
disconnect, or for large holes or leaks in the cushion, see the Limited Warranty supplement, or contact Customer Support.
Confirm that the inflation valve(s) are open. Inspect the inflation valve(s) and hose(s) for damage. For the Hybrid Elite SR:
also check the quick disconnect for damage.
- Make sure that the air cells are not underinflated or overinflated (see "Cushion Setup").
- Make sure that the foam insert and the cushion insert are correctly placed on the contoured foam base.
- Make sure that the foam insert does not overlap the air cells.
- The air cells and the top of the cover should face up.
- The cushion should be centered beneath the individual.
- The cushion should be properly sized to the individual and the wheelchair.
Allow the individual at least one hour to adjust to the cushion.
Make sure that the non-skid bottom of the cushion cover faces away from the individual. Use directional labels on the
cushion and on the cover to orient the cushion. When possible, use hook and loop fasteners to further secure the cushion to
the wheelchair. Hook fasteners are available upon request. Refer to the instructions provided with the cover.
Contact Customer Support for a replacement.
6
A
B
Center