Tunnel In One (1) Part - Vetus THRUSTER RimDrive RD125 Instrucciones De Instalación

Check that the distance between
the tunnel ends is correct: 248-250
mm (9 3 / " - 9 27 / ").
4 32
3 .7

Tunnel in one (1) part

Instead of a tunnel in two parts a
one part tube can be laminated as
well.
After installation of the tunnel the
middle part can be cut out.
Place the clamps temporarily on the
tunnel and use them as a marking
guide for the part the be cut out.
Check that the distance between
the tunnel ends is correct: 248-250
mm.
The ends of the tunnel must be
smooth and entirely free from weld
spatter or polyester or epoxy resi-
dues over a length of at least 10 cm.
Check this thoroughly!
This is necessary in order to obtain a
good watertight connection of the
RimDrive on to the tunnel.
Steel and aluminium tunnels must be treated with a complete paint
system in order to prevent galvanic corrosion of the Rimdrive.
vetus® Installation instructions thruster RIM DRIVE 250 mm
248 - 250 mm
3 27
(9 / " - 9 / ")
4 32
248 - 250 mm
(9 3 / " - 9 27 / ")
4 32
248 - 250 mm
(9 3 / " - 9 27 / ")
4 32
min. 10 cm (4") min. 10 cm (4")
n
ote
Apply on the tube ends a silicone-
free lubricant.
A lubricant for woodworking ma-
chines is extremely suitable.
For example: Bison Prof Houtgli-
jmiddel
Waxilit 22-2411
Ivana houtglijmid-
del 42066 Bostik®
GLIDECOTE®
Place the rubber sleeves on the
tube ends.
First place the plastic slabs on top of the rubber sleeves and then
place the clamping straps over these parts.
Tighten the bolts of the clamping straps just enough that the plastic
slabs remain in place.
A difference in diameter between the tunnel tube and the Rimdrive
may occur due to tolerances on the tunnel tubes.
Use the narrow rubber sleeves to overcome this difference.
Place the Rim Drive between the tube ends.
Apply a temporary support under the Rimdrive or use a hoist in order
to keep them in the right place.
ENGLISH
n
ote
25
020574.06