Tabla de contenido
Publicidad
Motor Shaft
Arbre du moteur
Eje del motor
Belt
Courroie
Correa
Motor Shaft
Arbre du moteur
Eje del motor
Carpet/Bare
Floor Selector
Shaft
Arbre d'entraînement
du sélecteur
tapis/plancher
Selector alfombra-piso
Belt
Courroie
Correa
End Cap
Bouchon
Tapa del extremo
Lower Plate
Plaque inféreure
Base inferior
All manuals and user guides at all-guides.com
Replacing Belt
Belt
Courroie
Correa
Agitator
Agitateur
Agitador
Belt Groove
Rainure de la courroie
Polea para correa
Agitator
Agitateur
Agitador
Front Slots
Fentes avant
Ranuras frontales
➢ ➢ Replace belt whenever a burning
rubber smell caused by excessive
slippage occurs.
➢ ➢ Place carpet-bare floor selector in
CARPET position.
➢ ➢ Remove lower plate.
➢ ➢ Remove agitator by carefully lifting
out.
➢ ➢ Remove worn or broken belt.
➢ ➢ Loop new belt around motor shaft
and brush pulley; see illustration for
correct belt routing.
➢ ➢ Clean agitator and reinstall the two
(2) end caps.
➢ ➢ Reinstall agitator back into nozzle
housing grooves.
➢ ➢ After reinstalling the agitator, turn it
by hand to make sure the belt is not
twisted or pinched and that all
rotating parts turn freely.
➢ ➢ Reinstall lower plate. Ensure tabs are
locked into slots.
- 48 -
Publicidad
Tabla de contenido
