Gfci Instructions; Operation - Kärcher HDS 3.5/23-4M Eg Manual De Instrucciones

DANGER
Risk of personal injury or damage! Never
suck in water from a drinking water contain-
er. Never suck in liquids which contain sol-
vents like lacquer thinner, petrol, oil or unfil-
tered water. The sealings within the device
are not solvent resistant. The spray mist of
solvents is highly inflammable, explosive
and poisonous.
Note: Assembly in reverse order. Ensure
that the solenoid valve cable on the reser-
voir of the system care is not pinched.
Power connection
– For connection values, see technical
data and type plate.
– The electrical connections must be
done by an electrician according to
NEC and local codes.

GFCI INSTRUCTIONS

 STEP 1: Plug the Ground Fault Circuit
Interrupter (GFCI) into a working outlet.
 STEP 2: Press ''TEST'', then press
''RESET'' to assure proper connection
to power.
Note: The actual appearance of the GFCI
may be different from this illustration.

Operation

DANGER
Danger of explosion! Do not spray flamma-
ble liquids.
DANGER
Risk of injury! Never use the appliance
without the spray lance attached. Check
and ensure proper fitting of the spray lance
prior to each use. The screw connection of
the spray lance must be finger-tight.
All manuals and user guides at all-guides.com
Risk of injury! Hold the hand spray gun and
the spray pipe firmly with both hands.
Risk of injury! The trigger and safety lever
may not be locked during the operation.
Risk of injury! Contact Customer Service if
the safety lever is damaged.
ATTENTION
Risk of damage! Never operate device with
an empty fuel tank. The fuel pump will oth-
erwise be destroyed.
 To open the trigger gun: Actuate the
 To close the hand spray gun: Release
Risk of injury! Switch the appliance off prior
to replacing nozzle and activate hand spray
gun until device is pressureless.
 Secure the trigger gun. To do so, push
 Replacing the nozzle.
0/OFF = Off
1 Operating with cold water
2 Eco operation (hot water max. 140 °F/
3 Operating with hot water/steam
– 6
EN
DANGER
DANGER
DANGER
Opening/closing the trigger gun
safety lever and trigger.
the safety lever and trigger.
Replace the nozzle
DANGER
the safety catch towards the front.
Operating modes
60 °C)
13