Adjusting Ph/Rx Setpoint; Programming; Enter In Programming Mode; Programming Menu - Aqua HC997-1 Manual De Instruccion

HC997-999 – MOD. D
Digital multifunction solenoid metering pump
3.3 A
DJUSTING THE CHLORINE SETPOINT
From the standby menu press three timer the
Press the keys to set the desired values ant then the
Press twice the key to go back at the standby menu.

After 10 seconds the pump automatically goes back to the standby menu if no key is pressed.

4.0 PROGRAMMING

4.1 E
NTER IN PROGRAMMING MODE
From the user menu, keep pressed the
To enter press the following key's combination:
ATTENTION: TO CONFIRM AND SAVE THE PROGRAMMING PRESS THE BUTTON
FOR 5 SECONDS
4.2 P
ROGRAMMING MENU
With the keys is possible scroll the menu's
choices.
To select the desired choice press
4.2.1 P
ROGRAMMING MENU DESCRIPTION
Constant functioning menu
It allows to select among the following functioning modes:
Proportional functioning menu
It allows to select the following functioning modes:

proportional by external pulses from a water meter 1:N mode

proportional by external pulses from a water meter 1xN mode

proportional by external pulses from a water meter 1xN mode with memory

proportional by external 4÷20 mA current signal

PPM

proportional by Chlorine Jumo
Timer functioning menu
It allows to programming the pump in daily or weekly timer mode.
Setting menu – Calibration
This menu allows to set all the functioning parameters of the pump and moreover to calibrate the pump.
ADSP9000033
All manuals and user guides at all-guides.com
key, the display will show the current setpoint.
key for three seconds, the display will show:
.
key
Capacity – Period – Quantity to dose – Cyclical
03/09/2015 Rev.1.2
PROGRAMMING
key to confirm.
ENGLISH
31/100