Tabla de contenido
Publicidad
WARNING! DANGER! The
failure to use this machine
correctly can be hazardous
for oneself and others.
PROJECTION HAZARD! Be
careful of flying debris projected
by the cutting means, that
can cause serious injuries to
persons or damage to things.
WARNING! Read the instruction
manual before using the machine.
Wear protection goggles.
Wear ear protection devices
Wear head protection device
Wear non-slip protective gloves.
Wear non-slip safety footwear..
Do not leave the machine in the
rain (or in damp conditions)
DANGER! Electrocution.
Keep a distance of at least 15
mt from overhead line cables.
Keep any people or pets
at least 15 mt away when
using the machine.
Remove the battery before
performing any inspections,
cleaning or maintenance/
adjustment interventions
on the machine:
IMPORTANT
decals must be replaced. Order replacement
decals from an authorised service centre.
4. ASSEMBLY
The safety regulations to follow
are described in chap. 2. Strictly
comply with these instructions to
avoid serious risks or dangers.
For storage and transport purposes, some
components of the machine may not be installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
Unpacking and completing the assembly
should be done on a flat and stable surface,
with enough space for machine handling
and its packaging, always making use of
suitable equipment. Do not use the machine
until all the instructions provided in the
"ASSEMBLY" section have been carried out.
4.1 UNPACKING
1. Carefully open the packaging, paying
attention not to lose components.
2. Consult the documentation in the
box, including these instructions.
3. Remove all the unassembled
parts from the box.
4. Remove the machine from the box.
5. Dispose of the box and packaging in
compliance with local regulations.
4.2 ASSEMBLY OF THE GUIDE
BAR AND TOOTHED CHAIN
Always wear heavy duty gloves when
handling the bar and chain. Mount the
bar and chain very carefully so as not to
impair the safety and efficiency of the
machine. If in doubt, contact your dealer.
Before assembling, make sure the
battery is not fitted in its housing.
1. Remove the knob (Fig. 3.A) and remove
the chain guard (Fig. 3.B), to access
the drive pinion and bar seat.
2. Mount the bar (Fig. 4.A) by inserting the stud
bolt (Fig. 4.B) in the groove (Fig. 4.C) and
push it towards the back of the machine body.
3. Mount the chain around the drive pinion (Fig.
5.A) and along the bar guide, being careful
to follow the sliding direction (Fig. 5.B).
EN - 7
Any damaged or illegible
Publicidad
Tabla de contenido
