Maintenance - Femi 2201 SPECIAL Manual De Instrucciones

6

MAINTENANCE

6.1 ROUTINE MAINTENANCE
The interventions of routine maintenance which can also
be carried out by unskilled personnel are described in this
paragraph and in the previous ones.
WARNING: Before any maintenance work,
disconnect the machine plug from the mains.
WARNING: During the maintenance works, always
wear protective gears (protective goggles and
gloves of adequate size).
AFTER EVERY USE
• If need be, remove any chip in the cutting area and on the
sawblade guides. We recommend the use of a brush or an
exhaust fan.
WARNING: The use of compressed air is absolutely
prohibited !!!
• Check for the correct height of suction of the pump from the
tank and make sure that the coolant comes out from both
dispensers placed on the sawblade guides.
EVERY WEEK
• Lubricate the slides of the sliding blade guide and the swivel
support and the nut screw of the chuck.
• Remove the chips from the area of the coolant collecting
fi lter.
• Clean the sawblade guide plates with a brush.
• Check that all machine safety guards are not damaged and
that the start push button works properly.
• If the saw is not used for a long period of time, clean and
store it in a place free from humidity. In this case, it is
advisable to loosen the blade in order not to keep it uselessly
tensioned.
6.2 REPLACEMENT OF THE COOLANT
The refrigerating emulsion must be replaced every 500
hours.
• Remove the plug from the wall outlet to disconnect the
machine.
• Empty the pump tank by removing cap M (Fig. 1) and remove
the chips inside of it, if any.
• Prepare the new emulsion, as specifi ed at item 4.1 and pour
it inside the tank. Make sure that the emulsion is properly
disposed of.
• For emulsion disposal, please refer to item 6.4.
6.3 AFTER-SALES SERVICE
In case of repair under guarantee, the receipt/purchase invoice
must be presented together with the machine.
The absence of this document will invalidate the guarantee
applied to the machine.
Should the presence of skilled personnel be necessary for
All manuals and user guides at all-guides.com
extraordinary maintenance work or in case the repair is
effected both under guarantee or after it, please always contact
an authorised centre or the dealer where you purchased
the machine, if an authorised centre is not present in your
region.
When you contact the after-sales service or the dealer, always
advise the purchase date of the machine and its serial number
engraved on the CE.
When ordering spare parts, information about the machine's
model, the serial number as well as the part code listed in
the spare parts table must always be given to the After-sales
Service.
6.4
NFORMATION FOR USERS
In accordance with art. 13 of Legislative Decree
25th July 2005, no. 151 "Implementation of
Directives 2002/95/EEC, 2002/96/EEC and
2003/108/EEC, relative to reducing the use of hazardous
substances in electrical and electronic appliances and the
disposal of waste", please take note of the following:
•
•
•
DISPOSAL OF THE MACHINE AND PACKAGING
The crossed out wheelie bin symbol found on the appliance
or on the packaging, indicates that the product must be
disposed of separately from ordinary household waste
when it reaches the end of its working life.
The user must consign the unwanted appliance to an
authorized differentiated waste disposal centre for electrical
and electronic goods, or alternatively, hand it over to the
relative dealer on purchasing a new appliance of the same
type on the basis of a one to one ratio.
Differentiated disposal, to enable possible recycling or
environmentally compatible elimination of the appliance,
helps to limit undesirable effects on health and the
environment and promotes the reuse and/or recycling of
the materials which went into making up the appliance.
WARNING: Sanctions, in accordance with the
relative legislation in force in the country of use,
will be imposed on the user if the appliance is
disposed
13