Good Earth Lighting RE1250-BKG-12LF1-G Manual Del Usuario

OPTION A
EASY INSTALLATION WITH COMMAND
IMPORTANT: Failure to follow instructions carefully may cause damage.
48 in.
Before 1st use, plug in USB wall
charger (not included) and micro
USB cord (included) to charge
product until indicator light turns
green.
CAUTION: Do not hang over beds or on wallpaper. Mount again with Command
REMOVAL
TO REMOVE PRODUCT
Grab edge of light and peel
from surface. Do not pull
straight off.
REMOVE PRODUCT TO:
1. Charge Battery.
2. Use as a portable light.
Remount by lining up strips
and press firmly.
OPTION B
SCREW MOUNT INSTALLATION
48 in.
Before 1st use, plug in USB wall
charger (not included) and micro
USB cord (included) to charge
product until indicator light turns
green.
BARRA DE MOVIMIENTO RECARGABLE DE 12 PULGADAS (PÁGINA 3)
Clean surface with rubbing
alcohol. Separate strips. Press
two strips together until they
click. Repeat with 2nd set of
strips.
TO REMOVE STRIPS PERMANENTLY
Never pull the strip away from
the surface! Always pull along
the surface.
Locate the sites for the
screws by measuring the
distance from the center from
one keyhole slot to the other.
12 IN. RECHARGEABLE MOTION BAR
Model #: RE1250-BKG-12LF1-G, RE1250-RGP-12LF1-G
RE1250-SIL-12LF1-G, RE1250-WHG-12LF1-G
STRIPS BY 3M
®
30
seconds
Remove one side of liners.
Place each pair of strips as
shown. Press firmly for 30
sec.
Small Picture Hanging Strips.
®
1/16in.
Mark the locations to install
the 2 screws. Carefully drive
screws in, leaving a little over
a 1/16" gap.
Remove remaining liners and press
onto surface. Press each side firmly
for 30 sec.
SLOWLY
Stretch each strip slowly against the
surface at least 6" to release.
Slide the product's 2 keyhole slots
over the 2 screw heads until both
sides are captured by the narrow
ends the keyhole slots.