Cleaning the appliance
m
WARNING
To avoid electrical shock which can cause death or
severe personal injury, disconnect power to appliance
before cleaning. After cleaning, reconnect power.
m
CAUTION
To avoid personal injuries or property damage, observe
the following:
– Do not clean the appliance with a steam cleaner.
– Do not let the water used for cleaning drip onto
the light or control panel.
– Do not use abrasive or acidic cleaning agents
or solvents which may damage the surfaces
of the appliance.
– Never clean shelves and containers
in the dishwasher. The parts may warp.
Switch off the appliance with the POWER button
Pull out the mains plug or switch off the fuse.
Clean the door seal with water only and dry thoroughly.
Clean the appliance with lukewarm water and a little
dishwashing liquid.
Do not let the water used for cleaning drip onto the
control panel or light.
Check the ventilation openings on the base panel.
Remove dirt with a vacuum cleaner.
After cleaning:
Reinsert the mains plug or switch on the fuse. Switch on
the appliance with the POWER button
NOTE
Have your supplier inform you about special cleaning and
care information for appliance surfaces.
Wipe appliance surfaces with a damp cloth.
Then immediately wipe dry.
All manuals and user guides at all-guides.com
m
m
O
!
O
.
Odors
If the appliance is emitting unpleasant odors:
Switch off the appliance with the POWER button
Clean the interior.
See section on "Cleaning the appliance".
Clean all packages.
Switch on the appliance again with the POWER
O
button
.
After 24 hours check whether the odors have been
eliminated.
Change the activated carbon air filter,
see "Changing activated carbon air filter".
Warning messages via the display
If several warning messages are displayed simultaneously,
deal with each message individually.
While a warning message is displayed, buttons cannot be
pressed.
Door alarm
Cause
An appliance door has not been closed properly or has been
open too long.
Remedial action
Close the door.
The display goes out.
O
!
19