Technical Specifications; First Use And Charging - Lenz rcB 1200 Manual De Instrucciones

OPERATING INSTRUCTIONS / ENGLISH
Charger
Power supply (Fig. 2.1)
￭
Charge indicator (Fig. 2.2)
￭
Charger plug (Fig. 2.3)
￭

TECHNICAL SPECIFICATIONS

Global USB power supply unit
(with exchangeable plug)
lithium pack rcB 1200
lithium pack rcB 1800

FIRST USE AND CHARGING

Important note:
The battery packs must be charged before using them for the first time.
Charging process
1. Connect the charging cable with the USB power supply unit and plug the USB power supply
unit into a socket. The charge indicator (Fig. 2.2) will light up green.
2. Remove the contact protector (Fig. 1.4) and connect both battery packs to the charging plugs
of the charging cable (Fig. 2.4). Please refer to the diagram on the charging plugs for correct
orientation. The battery packs can be charged in any operating mode.
3. The charging process starts after one-time operation of the control button (Fig. 1.3.).
4. The charge indicator (Fig. 2.2) will light up red during the charging process.
5. Once the battery packs are fully charged, the charging process automatically ends and the
charge indicator (Fig. 2.2) changes back to green.
6. The charging status can be monitored by looking at the LEDs on the battery pack, which will
light up in ascending order as the charge increases. It can also be optionally monitored with the
Lenz Heat App* convenient control app.
7. After the end of the charging process, please disconnect both battery packs from the charging
plugs.
Important note:
The percentage indicator in the Lenz Heat App* may show slightly different charging
￭
Input: 100 V - 240 VAC
(50/60 Hz), max. 150 mA
– 24 –
Output: 5V / 1A DC
Output: 3.7 V / 2400 mAh
Output: 3.7 V / 3600 mAh