Culligan US-DC1 Instrucciones De Instalación página 3

INSTALLATION
• Consult your local plumbing codes and install accordingly.
• Position on cabinet wall in a space that provides easy access for future cartridge
changes and is within reach of the water supply using the tubing provided.
• If you have anything other than flexible hose under your sink, check to see if you need
to purchase special fittings.
NOTE: Mount the filter system to a solid cabinet or wall. If a solid surface is not available,
use hollow-wall anchor bolts or toggle bolts (not included) to secure to the wall.
1
Turn off cold water shut-off valve then turn
on the kitchen faucet and allow all water to
drain from line.
2
Disconnect the cold water line from the cold
water shut-off valve.
4
3 3
Hand-tighten the water supply adapter to
the cold water shut-off valve as shown.
Hand-tighten the lower end of cold water
line onto the top of the water supply adapter.
5
Using the mounting bracket, mark with a
pencil the holes for the mounting screws on
the wall surface.
Using a 1/8˝ drill bit, drill two pilot holes
for the mounting screws. Insert mounting
screws into the wall with a screwdriver,
leaving approximately 3/8˝ of each mounting
screw exposed.
Hang the system head on the eyes of
the bracket.
4
2˝
Choose an easy-to-access area under the
sink to mount the filter system.
NOTE: Allow 2˝ of clearance below
system to allow space for filter changes.
The filter system must be mounted in a
vertical position.
NOTE: Filter head should be mounted on
a stud or firm surface.
6
INLET OUTLET
Determine two different lengths of 3/8˝
tubing needed to connect the system head
inlet and outlet to the water supply adapter
(reference image above for inlet and outlet
location). Make sure to allow enough tubing
to prevent kinking in the line.
Cut each 3/8˝ plastic tubing squarely on
both ends with a utility knife, making sure
not to crimp the tubing during cutting.
5