Wiring - Craftmade ATA52ABZ5 Guia De Instalacion

5. Fan Assembly. (cont.)
With the hanging bracket secured to the outlet box and able to
support the fan, you are now ready to hang your fan. Grab the fan
firmly with two hands. Slide downrod through opening in hanging
bracket and let hanging ball rest on the hanging bracket. Turn the
hanging ball slot until it lines up with the hanging bracket tab.
WARNING: Failure to align slot in hanging ball with tab in hanging
bracket may result in serious injury or death.
Tip: Seek the help of another person to hold the stepladder in place
and to help lift the fan up to you once you are set on the ladder.
Find a secure attachment point (wood ceiling joist highly
recommended) and secure safety cable. It will be necessary to use a
heavy duty wood screw, washer and lock washer (not supplied) to
secure the safety cable loop.
Replace vice on safety cable and adjust safety cable length by
loosening screw and nut on the safety cable vice and pulling on the
cable. Adjust slack in cable to a hands length and secure vice by
tightening screw and nut securely. [Refer to drawing at right.] The
loop at the end of the safety cable should just fit over the threads
on the wood screw. Test safety cable by pulling on loose end with
pliers. If the safety cable slips, the screw and nut on the vice must be set
tighter. Extra cable slack can be left in ceiling area.

6. Wiring.

CAUTION: Be sure outlet box is properly grounded and
that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with Local
Codes or Ordinances and the National Electrical Code. If
you are unfamiliar with electrical wiring or if the
house/building wires are different colors than those
referred to below, please use a qualified electrician.
Note: Excess lead wire length from the fan can be cut to
the desired length and then stripped.
When downrod is secured in place on the hanging
bracket, electrical wiring can be made as follows:
Connect BLACK and BLUE wires from fan to BLACK
wire from ceiling with wire connector provided.
Connect WHITE wire from fan to WHITE wire from
ceiling with wire connector provided.
Connect all GROUND (GREEN) wires together from fan
to BARE/GREEN wire from ceiling with wire connector
provided.
If you intend to control the fan light with a separate
light switch, connect BLUE wire from fan to the BLACK
(or RED) supply from the independent switch.
* Wrap each wire connector separately with electrical
tape as an extra safety measure.
This fan is remote control adaptable (remote control sold
separately).
All manuals and user guides at all-guides.com
page 5
wood ceiling joist
white supply wire
black supply wire
from
ceiling
black
white
white
black
blue
from fan
safety cable loop
wood screw
and washer
screw
nut
safety cable
hanging bracket tab
hanging ball slot
motor housing
ground
(green or bare)
wire
connector
ground
(green
or bare)
*