Bestway LAY-Z-SPA Manual Del Propietário página 9

surfaces are slippery.
• To avoid damage to the pump, the spa must never be operated
unless the spa is filled with water.
• Immediately leave spa if the user feels uncomfortable or sleepy.
• Never add water to chemicals. Always add chemicals to water
to avoid strong fumes or violent reactions that may result in
hazardous chemical spray.
• Whenever the spa is emptied, the filter should be cleaned (and
drained/dried, where applicable).
• Any manual dosing of chemicals shall not be performed while
bathers are present in the spa.
• Regarding the information pertaining to cleaning, maintenance
of water, and disposal of water, please see section
"MAINTENANCE".
• Regarding the information pertaining to the installation, thanks
to refer to the below paragraph of the manual.
• Please examine equipment before use. Notify Bestway at the
customer service address listed on this manual for any
damaged or missing parts at the time of purchase. Verify that
the equipment components represent the models that you had
intended to purchase.
• This product is not intended for commercial use.
• Transmitter working frequency ：2412~2472MHz
• Transmitter maximum output power：19dBm
Indoor and outdoor & above ground & portable wiring & portable
spa
WARNING: The selected location has to be able to support of
supporting the expected load.
WARNING: An adequate drainage system has to be provided to
deal with overflow water for both indoor and outdoor installations.
• Always keep the spa cover on to minimize heat loss during
heating of the spa between uses (but not while it is being
used). Ensure the cover is fitted tightly, as per instructions to
maximize insulation. It shall be recommended that the cover,
NOTE:
SAVE THESE INSTRUCTIONS
SELECTED LOCATION
9