Cover Removal And Installation - Permobil ROHO AGILITY Minimum/Mid Contour Back Support Instrucciones De Uso

Cover Removal and Installation

Warnings:
- DO NOT remove or install the AGILITY cover while the individual is in the wheelchair.
- DO NOT use an AGILITY without the cover, foam pad, and, if applicable, the air insert or foam insert.
- Inspect the cover for damage and replace if necessary.
To Remove the Cover
1. On the wide end of the shell: Pull down to release
the cover flap.
To Install the Cover
1. On the back side of the shell, push the tab, but
not the handle, through the slot at the narrow end.
Press to attach the tab to the shell.
To Remove the Foam Pad, Air Insert or Foam Insert
1. Unzip the cover.
2. Remove the foam pad from inside the cover with the insert still attached.
3. Detach the insert from the fastener strip in the cutout area of the foam pad.
4. For air inserts: Pull the valve hose back through the hole in the foam pad.
ROHO AGILITY Minimum/Mid Contour Back Support Operation Manual
2. Pull the cover away from the shell.
2. Lift the cover over the narrow end of the shell.
Make sure the zipper faces the shell, and press
to attach the cover to the front side of the shell.
3. Lift the cover over the narrow end of the shell.
Pull to release the hook fastener strip on the tab.
Pull the tab through the slot.
3. Pull the wide end of the cover over the wide
edge of the shell. Press to attach the cover flap
to the shell.
5