Cover Components - Air Insert Adjustment - Permobil ROHO AGILITY Minimum/Mid Contour Back Support Instrucciones De Uso

Cover Components - Air Insert Adjustment

Warnings:
- Check inflation frequently, at least once a day!
- The air insert must be used with the air cells facing the individual.
- The individual's comfort level may be reduced if an air insert is not
positioned correctly, is not properly sized to the foam pad, or is under-
inflated or over-inflated.
- If an air insert does not appear to be holding air, see Troubleshooting.
If the air insert is still not holding air, replace the air insert with the foam
insert and contact an equipment provider or Customer Support.
- Changes in altitude may require adjustment to an air insert. Check the
inflation level of any air inserts when changing altitude.
To Adjust the Air Insert
Notes: Before you adjust the air insert, make sure the cover with the foam pad and air insert are correctly installed on the back shell. See "Cover Removal and
Installation". Make sure that the AGILITY is correctly installed and adjusted on the wheelchair. Refer to the instructions provided with the AGILITY back support
hardware.
1. Slide the hand pump nozzle over the inflation valve. Open the inflation valve, at
least one full rotation. Inflate the air insert until it feels firm.
Note: The inflation valve will spin freely when open.
Open
Warning: Safely transfer the individual into the wheelchair.
3. Adjust the air insert, if desired:
a. The individual may be seated in the wheelchair in their normal position.
b. Open the inflation valve and remove air until the individual is comfortable.
Close the inflation valve. Make sure the inflation valve is closed.
Open
ROHO AGILITY Minimum/Mid Contour Back Support Operation Manual
Close
Cautions:
- DO NOT use the valve hose as a handle to carry or pull an air insert.
- DO NOT use an air insert as a water flotation device (e.g., a Life
Preserver).
- If an air insert has been in temperatures lower than 32° F (0° C) and
exhibits unusual stiffness, allow the cushion to warm to room temperature.
Repeat adjustment instructions before using.
- Keep air cells away from sharp objects.
- DO NOT use an air insert as a seat cushion. DO NOT use an air insert and
a foam insert together.
- DO NOT use a pump or repair kit other than those approved for use with an
air insert.
2. Close the inflation valve until it comes to a stop. Remove the hand pump.
Make sure the inflation valve is closed.
Warning: Safely transfer the individual out of the wheelchair.
4. Detach the flap closest to the zipper. Place the valve hose inside the
zipper. Zip the cover closed and reattach the flap.
7
Close