Publicidad
T-Connector Wiring Kit
INSTALLATION INSTRUCTIONS
1. Read instructions thoroughly before beginning.
2. Open the vehicle's trunk and remove the threshold plate
(Fig. 1A). Carefully pull back the
trunk liner on each side (Fig. 2) to
expose the tail light wiring harness
connectors.
3. Locate the vehicles tail light
wiring harness connectors behind
the trunk liner on each side of the
vehicle. The harness connectors
will appear similar to those found on the T-Connector
harness (Fig 3).
4. Beginning on the left (drivers) side,
carefully separate the vehicle harness
connectors, taking care not to damage the
locking tabs.
5. Position the T-Connector ends with
the yellow wires between the separated ends
and carefully press firmly together until the locking
tabs engage.
6. Route the T-Connector harness ends
with the green wires to the right (passenger)
side of the vehicle and repeat steps 3 & 4
using the right tail light harness connectors.
7. Locate a clean accessible mounting
location on the vehicle near the wiring
A
Fig. 1
Fig. 2
Fig. 3
Publicidad
