Publicidad
T-Connector Wiring Kit
INSTALLATION INSTRUCTIONS
1. Read instructions thoroughly before beginning.
2. Open the vehicles tailgate and remove each of the tail light housing
assemblies (Fig. 1A) by removing the screws on each housing.
3. Starting on the left (drivers) side
of the vehicle, route the T-Connectors
black box and the connectors with the
yellow and red wires up through the
access hole at the rear corner of the
vehicle and out through the tail light
opening (Fig. 1B).
4. Starting on the left (drivers) side,
Locate the wiring harness connectors attached
to the rear of the tail light housings. They will
be similar in design to those on the T-Connector
harness (Fig. 2). Disconnect the top black connector
from the taill light housing by pressing on the locking
tabs and carefully pulling the connector away from the
housing. Insert the T-Connector ends containing the
red wires between these seperated ends, ensuring that
the locking tabs engage.
Caution : Take care not to damage any locking tabs.
5. Disconnect the center grey connector from the tail light assembly
and insert the T-Connector end containing the yellow wire between these
seperated ends ensuring that the locking tabs engage.
6. Locate a clean accessible mounting location on the vehicle near the
wiring harness ends within reach of the white wire and grounding eyelet and
drill a 3/32" hole.
Caution: Take care not to drill through the body or any exposed
surface.
7. Mount the white wire using the ground screw and eyelet provided.
A
B
Fig. 1
Fig. 2
Publicidad
