Publicidad
T-Connector Wiring Kit
INSTALLATION INSTRUCTIONS
1. Read instructions thoroughly before beginning.
Starting at the rear of the vehicle, remove the tail light housings
by removing the screws (fig. 1).
Carefully pry the housings away from
the vehicle body by using a flat blade
screwdriver. There are alignment tabs
along the side of the housing (fig. 2).
Caution: Pry only at the indicated
points to avoid damage to the tail light
housings.
3. Beginning on the left (drivers) side,
remove the center connector from the tail light
housing, taking care not to damage the
locking tabs. This connector will be gray and
match those found on the T-connector
harness.
4. Position the T-Connector harness ends with the yellow wires
between the separated connector and the tail light housing.
Firmly press the connectors together until the locking tabs
engage.
5. Route the remainder of the T-Connector harness to the right
(passenger) side of the vehicle. The yellow wire should be
secured between the bumper and the bumper fascia.
6. Continuing on the right (passenger) side, remove the top
connector from the tail light housing, taking care not to damage
Fig. 1
Fig. 2
Publicidad
