Silvercrest SEGS 2200 B2 Instrucciones Breves página 16

electrician for advice. The installation should only be carried
out by a qualified electrician.
... the power cable must regularly be inspected for signs of dam-
age. If the power cable is damaged, the device must no
longer be used.
The device, the power cable and the mains plug must not be im-
mersed in water or any other liquids.
This device is not intended to be operated using an external timer
or a separate remote control system.
If the power cable of this device should become damaged, it
must be replaced by the manufacturer, the manufacturer's custom-
er service department or a similarly qualified specialist in order
to avoid any hazards.
Charcoal and similar fuels must not be used in this device.
Never leave the device unattended during operation in order to
be able to intervene in good time if malfunctions occur.
Unplug the mains plug immediately after each use to prevent ac-
cidental switching on.
Clean the device before using it for the first time (fol-
low the online instructions).
Packing materials are not children's
toys. Children should not be allowed to
play with the plastic bags: there is a risk
of suffocation.
When using it as a free-standing barbe-
cue: never allow children to run and
play in the immediate vicinity, in order
to prevent them from accidentally knock-
ing over the device or burning them-
selves.
When using it as a tabletop barbecue:
ensure that children are not able to pull
the device down from the work surface
by the power cable.
Keep the device out of the reach of chil-
dren.
Electrical devices can represent a dan-
ger to pets and livestock. In addition,
animals can also cause damage to the
device. For this reason you should keep
14 GB
animals away from electrical devices at
all times.
Protect the device from moisture, water
drops and water splashes.
If liquid gets into the device, disconnect
the mains plug immediately. Have the
device checked before reusing.
Never touch the device with wet hands.
If the device falls into water, disconnect
the mains plug immediately. Only then
is it safe to remove the device.
Only plug the mains plug into the wall
socket after the device has been com-
pletely assembled.
Only connect the mains plug to a prop-
erly installed and easily accessible wall
socket with earthing contact whose volt-
age corresponds to the specifications on
the rating plate. The wall socket must