Preparing The Temperature Station For Use - Auriol HG02132A-US Instrucciones De Utilización Y De Seguridad

and hold the Z
(only restart the outdoor sensor).
Preparing the temperature
station for use
Open the battery compartment
the back of the temperature station.
Remove the battery insulation strip.
Close the battery cover.
Connecting the temperature station
with the outdoor sensor and the
WWVB radio signal:
After removing the battery safety strip, the
temperature station will attempt to connect
with the outdoor sensor. This process can
take a few minutes. The
bol flashes. Once the temperature station
10
has successfully connected to the outdoor
sensor, the
flashing and the temperature is shown in the
LC display.
Note: If the temperature station does not
receive the signal from the outdoor sensor
within 3 minutes, the temperature station
automatically starts with the reception of the
radio time signal.
After successful reception of the outdoor sen-
sor signal or after 3 minutes, the temperature
station starts with the reception of the radio
time signal. This process can take up to 5 min-
utes and is indicated in the LC display by the
flashing
16 US-EN
Z
/ REGISTER button
Radio signal symbol
WWVB symbol
25
Radio signal sym-
10
.
2
21
on
stops