Operating Instructions; Important - RotoZip Zip Mate Manual Del Propietário

Zip Mate Attachment Specifications
TM
Housing
Knobs
Guard Foot
Guard
Key Features of Spiral Saw™ Power Tools
There are some standard features on the Spiral Saw™ models that you will
want to identify prior to operation. We are outlining these below on the Rebel
model, but you should be able to easily locate them on your particular model.
B
C
E
D
Model: REBEL
A
B C
On/Off Switch Shaft lock button
Collet nut
8
All manuals and user guides at all-guides.com
Pinion Gear
Removable
Storage Holder
Pinion Gear
Arbor
Flange Nut
A
D E
Wrench
Removable
storage area depth guide

Operating Instructions

1. Preparing the Spiral Saw ™ power tool
Make sure tool is in OFF position and disconnected from power source.
Remove base guide. Twist base guide, counter-clockwise, about 1/8 of a turn until you feel it
disengage. Lift off tool.
Remove Zip® Bit and collet nut. Depress and hold down shaft lock button. With standard
wrench loosen collet nut. Remove bit, collet nut and 1/8" collet from tool.
Install 1/4" collet. Place 1/4" collet in tool and loosely tighten collet nut over top of it.
Insert pinion gear
Insert pinion gear.
Depress and hold down the shaft lock
button. Place pinion gear into the collet
and position it all the way into the collet
system **. Use wrench to tighten collet
nut around gear.
** Special Note/Trouble-shooting: Some models have one extra step
in properly inserting the pinion gear:
Spiral Saw Model
SCS02 Cordless
SCS02 Cordless
*Serial Numbers are located on the
specification label on side of tool.
Insert pinion gear using
wrench as a spacer
Inserting pinion gear for the
above SCS02 Serial Numbers.
Depress and hold down the
shaft lock button. Place pinion
gear into the collet and leave
one wrench width between it
and the top of the collet. Use
wrench to tighten collet nut
around gear.
IMPORTANT: If you experience a loud grinding noise coming from a Spiral Saw™
power tool not noted in the listed SCS02 serial numbers, trouble-shoot the noise by
trying to reposition the pinion gear as noted in the above extra step. Afterwards, if you still
feel the sound is not quite right, call Roto Zip Tool Corporation's Customer Service
Department, Monday - Friday between 8:00am - 4:30pm CST. The toll free number in the
U.S. and Canada is 1-877-768-6947, or you can call 1-608-798-3737
Mounted pinion gear
Serial Numbers*
136192 - 137000
137265 - and higher
Specially mounted
pinion gear
.
9