Acuity Brands LITHONIA LIGHTING CDS Instrucciones De Instalación página 5

CAUTION: RISK OF PRODUCT DAMAGE
✓ Never connect components under load.
✓ Do not mount or support these fixtures in a manner that can cut the outer jacket or damage wire insulation.
✓ Controls for dimming, auto-sensing, or remote control of a luminaire that are not factory-wired to the
luminaire must be checked for compatibility with the luminaire prior to installation. LED fixtures must be
powered directly off a switched circuit.
✓ Unless individual product specifications deem otherwise: Do not restrict fixture ventilation. Allow for some
volume of airspace around fixture. Avoid covering LED fixtures with insulation, foam, or other material that
will prevent convection or conduction cooling.
✓ Unless individual product specifications deem otherwise: Do not exceed fixtures maximum ambient
temperature.
✓ Only use fixture in its intended location.
✓ LED products are Polarity Sensitive. Ensure proper Polarity before installation.
✓ Electrostatic Discharge (ESD): ESD can damage LED fixtures. Personal grounding equipment must be worn
during all installation or servicing of the unit.
✓ Do not touch individual electrical components as this can cause ESD, shorten lamp life, or alter
performance.
✓ Some components inside the fixture may not be serviceable. In the unlikely event your unit may require
service, stop using the unit immediately and contact an ABL representative for assistance.
✓ Always read the fixtures complete installation instructions prior to installation for any additional fixture
specific warnings.
✓ Always ensure that the electrical distribution system is up to NEC (and any applicable local code)
requirements.
✓ Verify that power distribution system has proper grounding. Lack of proper earth ground can lead to fixture
failure and may void warranty.
Failure to follow any of these instructions could void product warranties. For a complete listing of product Terms and
Our Brands Indoor/Outdoor
Lithonia Lighting
Carandini
Holophane
RELOC
Light Concepts
Acuity Brands Lighting, Inc. assumes no responsibility for claims arising out of improper or careless installation or handling of its products.
UT459795 REV D
Conditions, please visit www.acuitybrands.com.
Indoor Lighting
Gotham
Mark Architectural Lighting
Peerless
Renaissance Lighting
Winona Lighting
ABL LED General Warnings, Form No. 503.203
© 2010, 2016 Acuity Brands Lighting, Inc. All rights reserved. 12/01/10
LED IMPORTANT SAFETY INSTRUCTIONS
Outdoor Lighting Controls
American Electric Lighting DARK TO LIGHT
Antique Street Lamps LC&D
Hydrel ROAM
Tersen Sensor Switch
Synergy
Daylighting
SunOptics
Page 5 of 10