Use Procedure; Maintenance; Controller And Pump Startup; Pump Shutdown - Agilent Technologies Turbo-V 250 Manual De Instrucciones

Use Procedure

Controller and Pump Startup

To startup the controller and the pump apply mains to P17
connector.

Pump Shutdown

To stop the pump, you need to set jumpers b7-a5 on P17 connector,
or press the STOP button on the Hand Held Terminal if the controller
is configured in FRONT Mode.

Maintenance

The Turbo-V 250 series controller does not require any maintenance.
Any work performed on the controller must be carried out by
authorized personnel. When a fault has occurred it is possible to use
the Agilent repair service. Replacement controllers are available on
an advance exchange basis through Agilent.
WARNING! Before carrying out any work on the controller, disconnect it from the supply.
If a controller is to be scrapped, it must be disposed of in accordance
with the specific national standards.
Turbo-V 250 Controller User Manual / 87-900-856-01 (E)
Instructions for Use

Use Procedure

201/240
16