17
Technical Information
Interconnections
Interconnections
The following figure shows the Controller interconnections.
Figure 6
Connection P17 – Mains and Input/Output
Interconnections
Input/output signals and mains must be connected to J17 mating
connector (not provided). Make the connections with AWG 20 (0.5
mm
desired capability.
The following table describes the signals available on the connector.
Tab. 3
PIN
a8
a2
a2
a5
210/240
Controller interconnections
2
) to the pins indicated in the following figure, to obtain the
DESCRIPTION
GROUND power connection.
MAINS neutral connection.
MAINS line connection.
SIGNAL COMMON connection for all input/output signals.
Turbo-V 250 Controller User Manual / 87-900-856-01 (E)