Troubleshooting - Worx WG775 Manual Del Usuario

TROUBlE SHOOTING
Problem
1. Mower doesn't run when Switch
Lever is activated.
2. Motor stops while mowing.
3. Mower runs but cutting perfor-
mance is unsatisfactory, or does not
cut entire lawn.
4. Mower is too hard to push.
5. Mower is abnormally noisy and
vibrates.
3-in-1 Cordless lawn mower
All manuals and user guides at all-guides.com
A. Check to make sure that the Safety Key has been
installed and is fully seated and that the button on the
switch housing is being completely pushed.
B. Release Switch Lever to turn mower off. Remove
Safety Key, turn mower over and check that blade is
free to turn. If not free, return to an authorized servicer.
Blade should turn freely.
C. Has the Battery Pack been fully charged? Plug in
charger and wait for the green Charged Indicator Light
to come on.
A. Release the Switch Lever to turn mower off. Remove
the Safety Key, turn mower over and check that blade is
free to turn. If not free, return to an authorized servicer.
Blade should turn freely.
B. Raise cutting height of wheels to highest position and
start mower.
C. Has the Battery Pack been fully charged? Plug in char-
ger and wait for Charged Indicator Light to come on.
D. Avoid overloading the mower. Slow down the cutting
pace by pushing mower slower or raise the cut height.
Or both.
A. Has the Battery Pack been fully charged? Plug in
charger and wait for green Charged Indicator Light to
come on. "
B. Release the Switch Lever to turn mower off. Remove
safety key. Turn mower over and check the blade for
sharpness - always keep the blade sharp. Deck and
discharge chute for clogging.
C. Wheel height adjustment may be set too low for
grass condition. Raise cutting height.
A. Raise cutting height to reduce deck drag on grass.
Check each wheel for free rotation.
A. Release the Switch Lever to turn mower off. Remove
the Safety Key.. Turn mower on side and check blade
to ensure it has not been bent or damaged. If blade
is damaged, replace with a replacement blade. If the
underside of the deck is damaged return mower to a
authorized service center.
B. If there is no visible damage to the blade and the
mower still vibrates: Release the Switch Lever to turn
mower off, remove the Safety Key and remove blade.
Rotate blade 180 degrees and retighten. If mower still
vibrates, return the mower to an authorized service
center.
solution
19
EN