Sound Signs - BGS technic 70106 Instruction Manual

Heating indicator
•
This light is lit when the device output is activated.
Heating start button
•
The start-up button is always a part of the replaceable coil. The start-up button is always
a part of the replaceable coil. The device indicates the start when the green light by
heating a symbol and an acoustic intermittent signal, it is on audio devices.
Output power settings
•
Output power can be set between 10% and 100% in steps of 10%.
•
Output power is setting by turning the encoder always when light indicator
•
The menu is always the default power setting parameters and all other settings, the device after 5
seconds of inactivity in this mode always switches to the basic setting performance.
Heating timer
•
To set the exact time of heating is used with an adjustable timer interval 0 - 99.9 seconds,
which is on the panel marked with
•
By briefly pressing the encoder switches the device into timer mode setting, which is indicated by
green lights with timer symbol. By briefly pressing the encoder switches the device into timer
mode setting, which is indicated by green lights with timer symbol.
•
The timer setting can be 0.1 - 10 seconds after a step of 0.1 seconds and in the interval of 10 - 99
seconds the setting step is 1 second.
•
If the timer is activate, the timer symbol lights red.

Sound signs

•
During heating process sounds short sound in interval 300 micro second.
•
Error is indicate with sound in lenght 1 second.
•
When the time interval set by the timer expires, a tone in length is heard 0.2 seconds.
Sound signs during heating process is possible to turn on/off by pressing the encoder button for 3
seconds. In this case is shown on display of device following short reporting with sound sign:
•
bOn for turn on the sound sign.
•
boF for turn off the sound sign.
Remote control
•
The induction heater is equipped with remote control circuits.
•
This remote control can be implemented with the original control equipment to the PC via the
RS485 line or the superior automation system via external circuits.
•
With the remote control, it is necessary to use special inductors without buttons, designed for use
with a remote control so as to ensure the safety devices.
CONTROL AND UPDATES FIRMWARE VIA USB
The induction heater can be connected to a PC via USB, and it is possible to update the device
firmware with this connection.
REMOTE CONTROL CONNECTOR AND ITS CONNECTION
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
5
.
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
.
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed