Cleaning Instructions; Cleaning Care; Electric Scheme; Fax.: 02196 7204820 - BGS technic 70106 Instruction Manual

WARNING!!!
Use only original accessories intended for this induction heating. In the case of non-original
accessories used, the instrument manufacturer is not responsible for the correct operation of the
instrument, and damages caused by the use of non-original accessories are subject to the warranty
conditions.
STORAGE

The device has to be stored in a clean and dry room.

Protect the device from rain and direct sunshine and freeze.

After heating completion, leave the device switched on for 10 more minutes - it will be cooled
down by fans until it is cold, then it deactivates the fans. After that, turn it off using the master
switch and disconnect it from the power line. If you disconnect the device immediately, leave it
and all the working coils to cool down for at least 15 minutes.

CLEANING INSTRUCTIONS


Make sure the unit is turned off and unplugged. Use a dry, clean, non-abrasive cloth or paper
towel to remove grease, oil, and other dirt from the INDUCTION HEATER and electrical lead
before returning them to the storage case.

For grease, oil and dirt that is more difficult to remove, use a non-volatile cleaning product.

Allow all components to dry completely before using the INDUCTION HEATER.

CLEANING CARE


Do NOT immerse any components of the unit in water or a cleaning solution.

Do NOT spray the unit with water from a hose, or wash any parts under a stream of water from a
tap or shower.

Do NOT clean any components with volatile organic compounds such as petrol, benzene,
kerosene, methyl ethyl ketone (MEK), fuel oil, brake part cleaner, paint remover and thinners,
varnish removers, plastic adhesive solvents, etc. These substances are fire hazards and will
harden or dissolve the polymer materials used in the INDUCTION HEATER components.

Do NOT use heat guns, microwave or gas ovens, etc. to dry the components of the INDUCTION
HEATER.

ELECTRIC SCHEME

BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
8
Tel.: 02196 720480

Fax.: 02196 7204820

mail@bgs-technic.de

www.bgstechnic.com

© BGS technic KG, Copying and further use not allowed