Getting Ready To Sew; Connecting Machine To Power Supply; Before Using Your Sewing Machine; Foryour Safety - Sears Singer 384.18028300 Manual De Instrucciones

GETTING READY TO SEW
Connecting Mach ine to Power Sup p ly
(_ Power supply plug
Power switch
Outlet
Machine socket
(_ Machine plug
(_ Light bulb
Before connecting the power cord, make sure the voltage
and frequency shown on the machine conform to your
electrical power.
1. Turn off the power switch @. Insert the foot control plug
into the machine socket _.
2. Insert the power supply plug _ into the outlet _.
3. Turn the power switch @ to turn on the power and
sewing lights.
Before
Using Your Sewing
Mach ine
Before using your sewing machine for the first time, place a
waste fabric under the presser foot and run the machine
with thread for a few minutes. Wipe away any oil which may
appear.
ForYour
Safety
* While in operation, always keep your eyes on the sewing
area. Do not touch any moving parts such as the thread
take-up lever, handwheel or needle.
* Always turn off the power switch and unplug from the
power supply:
• When leaving the machine unattended.
• When attaching or removing any parts.
• When cleaning the machine.
* Do not place anything on the foot control, when not
sewing.
Polariz ed
Plug
This appliance has a polarized plug (one blade wider than
the other). To reduce the risk of electric shock, this plug is
intended to fit in a polarized outlet only one way. If the plug
does not fit in the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician to install the proper outlet.
Do not modify the plug in any way.
Foot Controller Model YC-482J-1 or TJC-150 is used with
Sewing Machine Model 384.18028XXX (XXX represents
numbers OOO through 999).
Controlling Sewing Speed
Sewing speed is varied by the foot control.
The harder you press on the foot control, the faster the
machine runs.
S
f-
S
\\
J
J
J