Chicco TOGETHER Manual Del Usuario página 22

close the velcro flaps before using the stroller.
INSTALLING THE CHILD CAR SEAT ON THE REAR SEAT OF
THE STROLLER
31. Recline the rear seat as far as possible following the
instructions provided in paragraph 22, now position the child
car seat inside the rear seat of the stroller, aligned with the
side anchor points (diag. 31A). The child car seat will then
automatically click into place (diag 31B). Try pulling the child
car seat upwards to check that it is fitted correctly.
HOW TO REMOVE THE CHILD CAR SEAT
32. To remove the child car seat from the stroller, press the
handle on the back of the car seat and lift it out of the stroller
(diag. 32).
ACCESSORIES
WARNING: The accessories described below are not necessarily
available on some versions of the product. Please read the
instructions relative to the accessories fitted on the type of
stroller you purchased carefully.
FULL-COVER RAIN HOOD
WARNING: Pay particular attention when using the rain hood.
33. To assemble the full-cover rain hood, thread the ties around
the stroller tubes and close the ties and velcro fasteners in the
positions indicated in diagram 33.
When you have finished using the rain hood, allow it to dry
properly if it is wet.
WARNING: the full-cover rain hood can not be used on a
stroller which has no hood or sun-hood as it could suffocate
the child.
WARNING: when the full-cover rain hood is fitted on the
stroller, never leave it exposed to direct sunlight with the child
inside, as the temperature will rise considerably.
LEG COVER
34. To use the leg cover on your stroller, close the velcro
fasteners on both sides after threading the leg cover under the
bumper bar, as illustrated in diagram 34.
Important Note: The pictures and instructions contained in
the booklet refer to the complete stroller model. Some of the
components and functions described here may vary according
to the model purchased.
22
E
IM
TR
TA
AT
NE
CO
EM
Q
AL
AD
•
•
•
•
•
•
•
•
•