Connecting Power; Initial Calibration - OHAUS Scout SKX Serie Manual De Instrucciones

Ocultar thumbs Ver también para Scout SKX Serie:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

TM
SCOUT
SERIES BALANCES - SKX

2.4 Connecting Power

AC Adapter Installation
AC power is used to power the scale when battery power is not needed. First, connect the AC
Adapter (supplied) to the AC Adapter Input receptacle at the rear of the balance then connect
the AC plug to an electrical outlet.
Interface Connection
Battery Installation
Install the four "AA" batteries with polarity as shown in the battery compartment.
Note:
After power on, it is recommended to let the balance warm up for at least 5 minutes before
using it.

2.5 Initial Calibration

When the Balance is first installed, and when it is moved to another location, it must be
calibrated to ensure accurate weighing results. The balance can be manually calibrated with
external masses. Have the appropriate calibration masses available before beginning
calibration. Refer to the Calibration Section for masses and calibration procedure.
1.800.561.8187
AC Adapter Input Jack
Security slot (Anti-theft lock slot)
Figure 2-3. Rear and bottom view of balance
www.
Weigh Below Hole
Security Switch
Battery Compartment Cover
information@itm.com
.com
EN-3

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Scout skx123Scout skx222Scout skx422Scout skx622Scout skx1202Scout skx2202 ... Mostrar todo

Tabla de contenido