Publicidad
Idiomas disponibles
Idiomas disponibles
5.- UNIT RECEPTION.
5.1.- Reception and unpacking.
• On receiving the unit, make sure that it has not been damaged in any way during transport, so it is best to unpack
it for a visual inspection and to make sure that its characteristics match those of the order (see the characteristics
plate adhered to the packaging). Otherwise, make all suitable claims to your supplier or, short of this, to our firm,
stating the manufacturing number of the unit and the delivery remittance references.
• Having completed the reception, it is best to pack the UPS once more until it is put into service in order to protect
it against possible mechanical knocks, dust, dirt, etc. In any case, we recommend that you do not discard the
packaging.
• The packing consists of recyclable materials, therefore, if they are to be thrown away, they must be disposed of
in accordance with applicable law.
5.2.- Storage.
• The unit must be stored in a dry premises, well-ventilated and protected from the rain, water projections or
chemical agents. It is best to keep the unit in their original packing as this packing has been specifically designed
to ensure maximum protection during transport and storage.
•
The UPS includes sealed lead-calcium batteries except in special cases, and they should not be stored for
more than 4 months without charging the batteries for at least 8 hours. This means that the unit should be connected
to the commercial mains and started. Once the batteries have been charged, it should be returned to its original
packing.
Do not store the apparatuses where the ambient temperature exceeds 40º C or falls under -20º C, as this might
deteriorate the electrical characteristics of the batteries.
6.- INSTALLATION.
• Check the "Safety warnings", see chapter 3.
• Make sure that the data on the characteristics plate are those required for the installation.
• Do not run the UPS when the temperature and humidity exceed the specified limits.
• In the UPS-700 to 1500 NX, make sure that the fuse (5) is in its place and connect the input cable supplied with
the unit to its base (0).
• The unit is supplied through the pluggable cable (1) and it must be connected to a grounded socket, without the
mains present (area contact open).
- 24 -
Publicidad
