Dremel 3D40 Traducción De Las Instrucciones Originales página 27

RK
Dremel3D If your 3D40 is not connected to a network, you can
om the update firmware directly from a USB Flashdrive.
1. On your web browser go to www.dremel3d.com/
s".
2. Add the 3D40 firmware file to an empty, FAT32
3. Turn off your 3D40 using the ON/OFF switch.
4. Insert the USB flashdrive into the USB-A port.
5. Turn on your 3D40 and it should automatically
6. Turn your 3D40 OFF, remove the USB flashdrive,
Clean the 3D40's exterior with a lint free cloth. Clear
the outer surfaces of any debris that is visible.
To avoid damaging your Dremel 3D40 do not use
water, chemicals or other cleaners on the 3D40.
!
atest
e to WHEN CLEARING DEBRIS. DREMEL 3D40 WILL NOT
WORK PROPERLY WITH DAMAGED EXTRUDER TIP
e latest AND WILL REQUIRE REPLACEMENT.
!
OPERATION OR UNTIL IT HAS COOLED DOWN TO
60°C (140°F). Contact with the extruder tip during or
after operation before tip has cooled may result in
personal injury.
Using small needle nose pliers, pull away any plastic
debris from the extruder tip.
If the debris is stubborn, the extruder may need to be
heated.
he Home
Wipe the touch screen with the soft, lint-free cloth. Do
not spray cleaners on the touch screen.
All manuals and user guides at all-guides.com
UPDATING FIRMWARE MANUALLY
support and download the latest 3D40 firmware file.
formatted, USB flashdrive.
detect and install the new firmware.
and turn ON again to complete the update.
CLEANING THE EXTERIOR
CLEANING THE EXTRUDER TIP
USE EXTRA CARE NOT TO
WARNING
DAMAGE THE EXTRUDER TIP
DO NOT TOUCH THE EXTRUDER
WARNING
TIP DURING DREMEL 3D40
CLEANING THE TOUCH SCREEN
27