Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY WARNINGS AND PRECAUTIONS
• Keep work area clean. Cluttered areas invite injuries.
• Observe work area conditions. Do not use machines or power tools in damp or wet locations.
Don't expose to rain. Keep work area well lighted. Do not use electrically powered tools in the
presence of flammable gases or liquids.
• Do not overreach. Keep proper footing and balance at times. Do not reach over or across
running machines.
• Maintain tools with care. Inspect tool cords and hoses periodically and, if damaged, kept clean,
dry, and free from oil and grease at all times.
• Remove adjusting keys and wrenches. Check that keys and adjusting wrenches are removed
from the tool or machine work surface before operating.
• Avoid unintentional starting. Be sure the air pressure is in the off position when not in use and
before making hose connections.
• Stay alert. Watch what you are doing, use common sense. Do not operate any tool when you
are tired.
• Check for damaged parts. Before using any tool, any part that appears damaged should be
carefully checked to determine that it will operate properly and perform its intended function.
Check for alignment and binding of moving parts; any broken parts or mounting fixtures; and any
other condition that may affect proper operation. Any part that is damaged should be properly
repaired or replaced by a qualified technician. Do not use the tool if any control or switch does
operate properly.
• Replacement parts and accessories. When servicing, use only identical replacement parts. Use
of any other parts will void the warranty. Only use accessories intended for use with this tool.
• Do not operate tool if under the influence of alcohol or drugs. Read warning labels if taking
prescription medicine to determine if your judgment or reflexes are impaired while taking drugs.
If there is any doubt, do not operate the tool.
• Maintenance. For your safety, service and maintenance should be performed regularly by a
qualified technician.
• Pacemaker safety warning. People with pacemakers should consult their physician(s) before
using this produce. Electromagnetic fields in close proximity to a heart pacemaker could cause
interference to, or failure of the pacemaker. In addition, people with pacemakers should adhere
to the following: Caution is necessary when near the coil, spark plug cables, or distributor of a
running engine. The engine should always be off if adjustments are to be made to the distributor.
• Note: Performance of this tool may vary depending on variations in air pressure and compressor
capability.
PRODUCT SPECIFIC SAFETY PRECAUTIONS
Caution: This equipment is designed to be operated by qualified and trained personnel. It should only
be operated after reading and understanding the safety warnings and operating procedures in this
instruction manual.
• Wear ANSI approved safety goggles.
• Do not smoke near this equipment.
• Use in a well ventilated area.
• When leaks are found in the equipment or hoses, immediately turn off the power switch and
repair the leaks.
• Immediately clean up any fluid spills or leaks.
• Do not use any cleaning compounds in this system.
• Keep an empty plastic bucket nearby in case of leaks.
• Keep a type ABC fire extinguisher nearby in case of fires.
• Always protect your skin and eyes from contact with oil and solvents.
Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot cover
all possible conditions and situations that may occur. It must be under- stood by the operator that
common sense and caution are factors which cannot be built into this produce, but must be supplied
by the operator.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
