Lid Assembly - vitapur GWF8BLK Manual De Instrucciones

Assembly (continued)

LID ASSEMBLY

8. Position the lid ring onto the upper chamber, making
sure both contours are aligned. Press fit together.
Caution: Do not push lid back forcefully.
UPPER CHAMBER ASSEMBLY
9. Align the two ports and locking tabs at the bottom of
the pre-filter with the holes in the upper chamber and
snap it into place.
10. Twist the soaked filter onto the base of the upper
chamber. Securely tighten the filter to the housing to
make a tight seal for effective filtration.
Place your assembled upper chamber on top of the
lower chamber.
MANUAL FILTER CHANGE REMINDER
11. To use the manual filter change reminder, turn the
dial on the lid until the number in the green circle
coincides with the month that the filter is being
installed. The number that appears in the red circle
will be the month to replace your filter. Repeat above
step for every filter change.
Caution: Once the filtration system is placed on the water dispenser
it should fit level and secure. The float mechanism that fits inside the
water dispenser must NEVER be obstructed and be allowed to operate
freely!
8
9
10
11