Prior To Commissioning - diversey TASKI swingo 755B Manual Del Usuario

• Tank position before change of posi-
tion.
• Stand behind the machine.
• Carefully open the battery compart-
ment until the driving handle is on the
ground.
• Carefully open the battery compart-
ment until the driving handle is on the
ground.
After maintenance, carefully tilt the tank back to its initial posi-
tion and lock it.
Notice:
Lift the suction nozzle again
Notice:
Connect the battery with the machine at
the battery disconnection socket.
88

Prior to commissioning

Relocation drive
• Switch on the machine (key switch).
The display lights up briefly.
The battery level indicator notifies
you that the machine is ready for op
eration. (In case of malfunctions,
please see page 95).
• Take the driving handle and arrange
the height of the driving switches in
such a way that you can work easily
with them.
• By gently pushing the driving switch
into the direction of movement, the
machine is set into motion. If you let
go of the driving switch, the machine
will stop.
Brush installation
Before inserting, please check:
• that the brush does not fall below the red marking (bristles)
or 1cm of bristle length.
• the pad for wear and cleanliness before use.
Attention:
Do not use brushes which have reached
their wear limit. The wear limit is indicated
by the length of the red bristle. Do not use
worn or contaminated pads. Use original
TASKI brushes only. Failure to observe
these instructions may result in inade-
quate cleaning results or even floor dam-
age.
• Position the tools under the tool unit.
• Switch the machine on.
The indicator elements lights up briefly.
Variant: Automatic brush lowering (Option 1255B)
• Press the Brush drive button ON/
OFF.
While lowering the brush will slowly
start to pulse. In this way the tool is
centered and engaged.
The display lights up.
Variant: Foot pedal
• Unlock the foot pedal and lower the
tool slowly.
While lowering the brush will slowly
start to pulse. In this way the tool is
centered and engaged.
The brush drive display lights up.
Notice:
When the brush is down, gently moving
the machine back and forth can make the
clutch easier to engage.
-