Publicidad
Step 12
Separate the NARROW EXTENSION SLIDES (DD) from the NARROW EXTENSION RAILS (CC) as shown in the upper
å
diagram below. Be prepared, the parts are greasy.
Fasten two NARROW EXTENSION RAILS (CC) to the RIGHT END (A) and RIGHT UPRIGHT (D). Use four GOLD 5/16"
å
FLAT HEAD SCREWS (3S) through holes #1 and #3.
NOTE: For each NARROW EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide
å
the inner cartridge of the NARROW EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the END and
UPRIGHT. Turn a SCREW into this hole.
NOTE: The NARROW EXTENSION SLIDES will be used later for the SMALL DRAWER and PENCIL DRAWER.
å
Open end
www.sauder.com/services
DD
Push the black lever in and pull the SLIDE from the RAIL.
GOLD 5/16" FLAT HEAD SCREW
4
3
2
CC
1
D
3S
(4 used in this step)
3
4
421934
CC
Open end
1
2
CC
A
Page 17
Publicidad
