Publicidad
Step 25
Step
1
D30
X
Groove
Insert the SMALL DRAWER SIDES (D30 and D31) at
å
an angle into the slot at each end of the SMALL
DRAWER FRONT (X).
3
Do not use
this hole.
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
NOTE: The SMALL drawer will only use two SCREWS in this step. Refer to the diagram.
å
Fasten the SMALL DRAWER BACK (D77) to the SMALL DRAWER SIDES (D30 and D31). Use two
å
BLACK 1-9/16" FLAT HEAD SCREWS (30S).
NOTE: Be sure the SMALL DRAWER BOTTOM (D716) inserts into the groove of the SMALL
å
DRAWER BACK (D77).
Page 30
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D31
D77
D30
D716
VIEW THE T-LOCK BOX VIDEO
2
D30
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the SMALL DRAWER BOTTOM (D716) into the
å
grooves in the SMALL DRAWER SIDES (D30 and D31)
and SMALL DRAWER FRONT (X).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D31
NOTE: Do not use this hole
in the SMALL drawer. This
hole will be used in Step 27.
421934
With the palm of
your hand, tap the
DRAWER BOTTOM
U n
down into the groove.
fi n
s u
i s h
r f a
e d
c e
D716
D31
X
30S
(2 used in this step)
www.sauder.com/services
Publicidad
