Publicidad
Step 19
Step
Carefully stand your unit upright.
å
Fasten the HINGES (14H) to the DOOR (V). Use four BLACK 1/2"
å
FLAT HEAD SCREWS (11S).
Before fastening the DOOR to your unit, be sure the mounting
å
screw is against the stops as shown in the diagram. If it isn't,
loosen the mounting screw to slide it against the stops. Then
tighten the mounting screw.
Fasten the DOOR (V) to the LEFT END (B) as shown in the lower
å
diagram. Use the screws in the HINGES. You should start each
SCREW a few turns before completely tightening any of them.
Fasten a KNOB SET (136K) to the DOOR (V). Use one BLACK
å
1-1/8" MACHINE SCREW (21S).
Insert the DOOR STOP (4I) into the hole in the LEFT UPRIGHT (E).
å
See the next step for DOOR adjustments.
å
Mounting
screw
Hinge
21S
BLACK 1-1/8" MACHINE SCREW
(1 used for the KNOB SET)
Page 24
Stop
136K
V
B
E
4I
421934
V
14H
BLACK 1/2" FLAT HEAD SCREW
(4 used for the HINGES)
11S
www.sauder.com/services
Publicidad
