Publicidad
Storage Temperature...-4°F to 158°F
(-20°C to 70°C)
Water Resistance........Image head and
extensions to 10'
(3.05 m) water depth
(When assembled.)
Maximum Distance ....Optional cable ex-
tensions can be as-
sembled to make
cable up to 30'
(9.74 m) long
Standard Equipment
The SeeSnake micro Inspection Camera
comes with the following items:
Hand Held
Display Unit
Imager Head
and Cable
Accessory
Hook
Figure 1 – System Components
Assembly
To Install Batteries (4 AA):
NOTE! Be sure to read Battery Precautions
section on Page 2 .
1. Turn the hand-held viewer upside down to
expose the battery compartment cover
and screw (Figure 2) .
Screw
Battery
Compartment
Cover
Figure 2
All manuals and user guides at all-guides.com
SeeSnake
2. Using a Phillips head screwdriver, re-
3. Remove battery compartment and insert
Figure 3
4. Replace battery compartment, making
5. Replace battery cover (Figure 2) and
Accessory Magnet
To use the display unit ( Figure 1) , it must
be connected to the imager head cable.
To connect the cable to the display unit,
make sure the keyed ends (Figure 4) are
Accessory
properly aligned. Once they are aligned, fin-
Mirror
ger tighten the knurled knob to hold the con-
nection in place.
Figure 4
To Install an Accessory:
The three included accessories, (mirror, hook
and magnet) (Figure 1) all attach to the imager
head the same way.
To connect, hold the imager head as shown in
Figure 5 . Slip the semicircle end of the acces-
sory, over the flats of the imager head as
shown in Figure 5 . Then rotate the acces-
sory a
sory is extending out as shown in Figure 6.
Ridge Tool Company
®
micro
™
Inspection Camera
move screw and cover.
four (4) new AA batteries into the proper
slots in the battery compartment (Figure
3) . Proper battery orientation is indicated
on the battery compartment.
Battery Compartment
Fin
sure the fin is oriented as shown with its
taller portion toward the LCD screen.
screw.
Keyed Ends
1
/
turn so the long arm of the acces-
4
5
Publicidad
Capítulos
