Satelec SUPRASSON P5 NEWTRON Manual Del Usuario página 9

All manuals and user guides at all-guides.com
b) Rear panel of the control unit
The S P5 N is connected to the
®
UPRASSON EWTRON
electrical supply using the mains cord and
earthed plug.
The tube used for connecting the device to the
water supply includes a filter (requires regular
maintenance; see section 7.2).
Of the "ON/OFF" type, the footswitch is used for
operating the S P5 N
UPRASSON
practitioner. Its weight and its non-slip base
ensure good stability.
c) Right side panel of the control box
The cord (blue) linking the device and the
handpiece connector provides for:
- the circulation of fluid for the spray
- the electrical connection between the
S P5 N and the handpiece.
®
UPRASSON EWTRON
The handpiece support can be replaced in case of
wear or breakage (see section 7/7.3).
d) Technical specifications
Mains power supply: 115-230 V~ 50 / 60 Hz.
Note: the voltage used is factory set. The device
is protected by fuses (not accessible by the user).
Class 2 BF type equipment.
Intermittent operation: 10 mins. operation / 5
mins. rest
Maximum power consumption: 30 VA.
Minimum frequency of vibrations: 27 KHz.
Water pressure at inlet: 1 to 5 bar (14 to 72
by the PSI).
®
EWTRON
Water filter: 60 µm.
Turn half way to adjust water flow 0-90 ml/min
Overall dimensions:
Control unit:
Width: 150 mm
Depth: 170 mm
Footswitch:
Width: 70 mm
Depth: 95 mm
Cord: 2000 mm
Handpiece cord: 2000 mm
Operating temperature:
+10 to +40°C at a maximum of 95% relative
humidity without condensation.
Storage temperature:
-20 to +70°C at a maximum of 95% relative
humidity without condensation.
This equipment is manufactured according to
current C.E.I. 601-1, C.E.I. 601-1-2 (certification
O.C.CB scheme) regulations and standards and
according to the EN ISO 13485 quality control
certification system.
Height: 55 mm
Weight: 900 gr
Height: 30 mm
Weight: 150 gr
9