vitapur VWD1066BLS Manual De Uso Y Cuidado página 7

Pre-Operation (continued)
INITIAL PRODUCT CLEANING PROCEDURE
To maintain a hygienic environment within your water dispenser and prevent potential for-
mation (growth) of bacteria, we strongly recommend regular cleaning (i.e every 4 months).
A cleaning kit is available through our Customer Service Department at 1-866-253-0447
or can be ordered on line at www.greenwayhp.com.
1. Make sure the lower compartment storage door is open (this will prevent activation
of the water pump).
2. Make sure the power cord is plugged into electrical outlet.
3. Using a clean jug/container pre-mix (50ml / 1.7ozs) water dispenser cleaner with
2L / 0.5 gal of hot water.
4. Place the jug/container on the floor of the bottle storage compartment.
5. Insert the stainless straw into the cleaning solution, (make sure the jug/container
does not tip over) and close the storage door. The water pump will start automatically
and draw the cleaning solution into the dispenser reservoirs. When all of the cleaning
solution has been drawn, the pump will continue to operate for approximately 20
seconds and stop automatically, followed by a flashing yellow light (add water)
condition (this is normal). Simply open the storage door to cancel the flashing yellow
light.
6. Allow the cleaning solution to sit inside the dispenser for 20 min.
7. Place a jug/container under the dispensing spigots and press both the hot and cold
dispensing buttons until the cleaning solution stops flowing. Discard cleaning
solution.
8. Using a jug/container, drain the remaining cleaning solution from the internal
reservoirs by unscrewing the drain cap and removing the drain plug from the drain
valve located at the back of the unit. Discard the cleaning solution.
9. Re-install the drain plug and drain cap on the unit and flush the system using 2L
clean water only (no cleaning solution) following the same basic steps outlined above.
Place a jug/container under drain valve and remove drain cap and drain plug allowing
the rinse water to drain.
10. When the rinse water stops flowing, re-install the drain plug and drain cap and
tighten. The cleaning process is now complete.
INSTALLING THE WATER BOTTLE
Important:
the top of the water bottle with a clean cloth. Water bottles can be purchased
from your local retailer.
1. Make sure the lower door (bottle storage compartment) is open. The water pump
cannot operate as long as the door is in the open position.
2. Remove the protective label from the top of the bottle.
3. Most water bottles have a puncturable membrane in the top cap. To puncture the
membrane, insert the straw into the cap and push downward until the membrane
opens.
4. Insert the straw all the way into the bottle until the bottom of the straw touches
the bottom of the water bottle.
Note:
The water bottle drinking straw features an exclusive telescopic design for use
with either 5 gallon and 3 gallon water bottles. To adjust the length of the water bottle
drinking straw, hold the upper portion of the straw and simply pull/push the lower
portion of the straw to the desired length.
5. To attach the water bottle straw onto the neck of the water bottle, make sure the
handle is positioned "horizontally" and press firmly onto the top of the bottle neck.
All manuals and user guides at all-guides.com
Always wash your hands first before handling water bottle! Clean
Note:
The stainless steel cap and
handle is not available on all models.