Fein BLK1.3T Manual Del Usuario página 21

3 41 01 100 06 0.book Seite 21 Freitag, 5. Dezember 2008 11:55 11
BLK2.0/BLK3.5: For template cuts, the template is traced
via the lower cylindrical part of the punch guide. The
clearance between template and the actual cutting edge is
2.5 mm. The template should be at least 2 mm thick; the
total thickness of template and work piece may not
exceed 5.5 mm.
BLK1.6: For cutting deep-channel trapezoidal sheet metal,
the optionally available profile set can be mounted (see
page 14).
Repair and customer service.
Use a stationary extraction system, blow out
the interior of the power tool via the ventila-
tion slots frequently with dry and oil-free
compressed air, and connect a residual current
device (RCD) on the line side. When working metal
under extreme operating conditions, it is possible for
conductive dust to settle in the interior of the power
tool. The total insulation of the power tool can be
impaired.
Lightly grease the sliding surfaces between die
holder and punch.
If the supply cord of this power tool is damaged it must
be replaced by a specially prepared cord available
through the FEIN customer service centre.
If required, you can change the following parts yourself:
Application tools
Warranty and liability.
The warranty for the product is valid in accordance with
the legal regulations in the country where it is marketed.
In addition, FEIN also provides a guarantee in accordance
with the FEIN manufacturer's warranty declaration.
The delivery scope of your power tool may include only
a part of the accessories described or shown in this
instruction manual.
Declaration of conformity.
FEIN declares itself solely responsible for this product
conforming with the relevant provisions given on the last
page of this Instruction Manual.
Environmental protection, disposal.
Packaging, worn out power tools and accessories should
be sorted for environment-friendly recycling.
en
21