Closing Stop Distance; Bot A Setting - Nice M-BOARD Instrucciones De Seguridad Y Advertencias Para Instalación, Uso Y Garantía

14 - CLOSING STOP DISTANCE

Attention: This function works only on machine models that do not
have limit switches and are with encoder sensor. Model identification
is done automatically during the path learning process.
In this function it is possible to adjust the distance that the control unit
will turn off the engine in the close direction before touching the stop.
Once selected, return the PROG switch to the OFF position (all
down) for the control panel to save the configuration.

15 - BOT A SETTING

To set "BUTTON A" set the PROG switch to the position as shown
in the figure below, and press the LEARN button according to the
desired setting:
78
ON
1 2
LED blinks 1 time
LED blinks 2 times
LED blinks 3 times
LED blinks 4 times
LED blinks 5 times
ON
1 2
LED blinks 1 time
LED blinks 2 times Opening only*
(Table continues on next page...)
DP
3 4 5 6 7 8
Short
Short average
Average*
Long average
Long
DP
3 4 5 6 7 8
Pulse
ENGLISH