Complete The Finished Wall; Clean-Up After Installation - Kohler K-1315 Guia De Instalacion

Whirlpool

17. Complete the Finished Wall

If you have not already done so, carefully remove any protective tape from the whirlpool rim.
Cover the framing with water-resistant wall material. Seal the joints between the whirlpool rim edge
and the water-resistant wall material with silicone sealant.
Tape and mud the water-resistant wall material. Install the finished wall to the water-resistant wall
material. Seal the joints between the whirlpool rim and the finished wall material with silicone
sealant.
Install the faucet trim according to the instructions packed with the trim.

18. Clean-Up After Installation

When cleaning up after installation, do not use abrasive cleansers, as they may scratch and dull the
whirlpool surface. If necessary, use warm water and a liquid detergent to clean the surface of the
whirlpool, user keypad and remote control.
Remove stubborn stains, paint, or tar with turpentine or paint thinner. Do not allow cleaners
containing petroleum distillates to remain in contact with any whirlpool surfaces for long periods
of time. Remove plaster by carefully scraping with a wood edge. Do not use metal scrapers, wire
brushes, or other metal tools. Use a powder-type detergent on a damp cloth to provide mild
abrasive action to any residual plaster.
1022405-2-C
All manuals and user guides at all-guides.com
Concrete Wall
or Studs
Water-Resistant
Wall Material
Finished Wall
Apply silicone
sealant to the joint
between the
whirlpool and the
finished wall.
Tile should be within 1/4"
(6 mm) of deck surface.
Reinstall the apron by pressing
Fastener
the apron against the seal, then
swing in the apron bottom.
Press the
suction cup
onto the
bottom
corner of the
apron, then
pull steadily
outward.
12
Apron
Kohler Co.