Install The Corner Post; Attach The Receptor/Bench To The Whirlpool; Attach The End Panel To The Whirlpool - Kohler K-1315 Guia De Instalacion

Install the Corner Post

Three
Large
Holes
First position and
install the corner post
in the front corner of
the whirlpool.
4. Install the Corner Post
CAUTION: Risk of product damage. Do not force the corner post into position, or use it to adjust the
whirlpool height or level.
Position the corner post in the unsupported front corner of the whirlpool so the three large holes are
toward the side of the unit. Identify the predrilled holes in the wood block on the underside of the
whirlpool. Secure the corner post to the block with the two screws provided. Tighten securely.
If it is necessary to adjust the height of the corner post, loosen the two hex nuts securing the corner
post top bracket in place. Slide the adjustment bracket up or down as needed to achieve a good fit.
You may need to repeat this step for the bottom bracket. Hand tighten the hex nuts.
If this whirlpool will be assembled to a receptor and bench, proceed to the "Attach the
Receptor/Bench to the Whirlpool" section. If the whirlpool will be installed alone, proceed to the
installation instructions packed with the optional apron and end panel. Then proceed to the "Attach
the End Panel to the Whirlpool" section.

5. Attach the Receptor/Bench to the Whirlpool

Whirlpool/Receptor Combinations Only
If you have not yet assembled the bench to the receptor, do so now by following the instructions
packed with the receptor. Then lift the whirlpool slightly along the outside end, and insert the
bench top flange into the groove underneath the whirlpool rim.
Position the bench so the side flange is behind the corner post. Align the three fastener holes in the
bench with the holes in the corner post, and loosely fasten the bolts and hex nuts.
Use a carpenter's square to square the corner post, whirlpool, receptor, and bench with the floor.
Secure the corner post firmly to the floor with two screws.

6. Attach the End Panel to the Whirlpool

Whirlpool Only Installations
Lift the whirlpool slightly along the outside end, and insert the end panel top flange into the groove
underneath the whirlpool rim.
Position the end panel so the side flange is behind the corner post. Align the three fastener holes in
the end panel with the holes in the corner post, and loosely fasten the bolts and hex nuts.
Use a carpenter's square to square the corner post, whirlpool, and end panel with the floor. Secure
the corner post firmly to the floor with two screws.
Kohler Co.
All manuals and user guides at all-guides.com
Whirlpool Front Corner
Wood Block
Predrilled
Holes
Adjustable Bracket
Screw
Three Fastener Holes
Then adjust the corner
post height by loosening
the hex nuts.
Attach the Receptor/Bench or End Panel
Top Flange
Receptor/Bench
or End Panel
Side Flange
Screw
Corner Post
Screws
7
Fit the top flange
into the groove.
Washer
Hex Nut
Lift the whirlpool
slightly, and insert
the receptor/bench
or end panel.
1022405-2-C