Omega NC900HDSS Manual Del Usuario página 13

ASSEMBLY INSTRUCTIONS
(1) Connect drum with main body by turning locking clip clockwise (about 60°).
(2) Place the auger into the drum. It will click into place.
TO JUICE (2A)
I. Place juicing screen onto auger. The screen should be facing down. Push into place.
II. Place drum cap onto end of juicing screen. Turn drum cap counter-clockwise until it
locks into place.
III. Attach adjustable pressure end cap to the drum cap end. Turn the adjustable p
ressure end cap counter-clockwise until it tightens. Turn clockwise to loosen
pressure. Set at lower numbers for soft fruits. Set at higher numbers for maximum
pressure.
IV. Place juice container under juice spout and pulp container under pulp ejector
spout (at end of drum end cap.)
V. Plug the power cord into wall outlet. Turn the power switch to ON.
VI. Feed properly sized ingredients into hopper chute. Press down with pusher.
NOTE: If too many fruits or vegetables are in the hopper, the operation may stop.
Try reversing the operation. If juicer doesn't operate, you will need to disassemble
and re-assemble.
TO PROCESS FOOD (2B)
I. Place blank cone onto auger. Push into place.
II. Place drum cap onto end of blank cone. Turn drum cap counter-clockwise until
it locks into place.
III. Attach preferred nozzle onto drum cap, turn until it locks into place.
IV. Place container at end of drum end cap to catch processed food.
V. Plug the power cord into wall outlet. Turn the power switch to ON.
WARNING When using [ON] or [Rev] button, make sure that the auger stops completely.
2A
Juicing Screen
Drum Cap
Pressure Cap
2B
Blank Cone
Nozzle
Drum Cap
Hopper
Auger
Drum
Hopper
Auger Drum
11