Synergic Curves Screen - Selco Genesis 3000 MTE Instrucciones De Uso

500 Allows the selection of the required graphic interface:
XE (Easy Mode)
XA (Advanced Mode)
XP (Professional Mode)
Allows access to the higher set-up levels:
USER: user
SERV: service
SELCO: Selco
551 Lock/unlock
Allows the locking of the panel controls and the inser-
tion of a protection code (consult the "Lock/unlock"
section).
552 Buzzer tone
Permits adjustment of the buzzer tone.
Minimum Off, Maximum 10, Default 10
553 Contrast (LCD 4.7")
Permits adjustment of the display contrast.
Minimum -20, Maximum +20, Default 0
601 Regulation step
Allows the regulation of a parameter with a step that
can be personalised by the operator.
Minimum 1, Maximum Imax, Default 1
602 External parameter CH1, CH2, CH3, CH4
Allows the management of external parameter (mini-
mum value, maximum value, default value, parameter
selected).
(Consult the "External controls management" section).
606 U/D torch
Allows the management of the external parameter
(CH1) (parameter selected).
705 Circuit resistance calibration
Lets you calibrate the system.
Press the encoder knob to access parameter 705.
Place the tip of the wire guide in electrical contact with
the work piece.
Press and hold the torch trigger for at least 1 s.
751 Current reading
Allow the real value of the welding current to be dis-
played.
Allows the welding current display method to be set
(consult the "Interface personalisation" section).
752 Voltage reading
Allows the real value of the welding voltage to be dis-
played.
Allows the welding voltage display method to be set
(consult the "Interface personalisation" section).
757 Wire speed reading
Allow the value of the motor encoder 1 to be displayed.
760 (Motor) Current reading
Allow the real value of the (motor) current to be dis-
played.
761 Wire speed reading
Allow the value of the motor encoder 2 to be displayed.
762 (Motor) Current reading
Allow the real value of the (motor) current to be dis-
played.
763 Wire speed reading
Allow the real value of the wire speed to be displayed.
764 Coolant flow reading
Allow the value of the coolant flow reading.
48
All manuals and user guides at all-guides.com
765
801

3.6 Synergic curves screen

1
Coolant temperature reading
Allow the real value of coolant temperature reading to
be displayed.
Guard limits
Allows the setting of the warning limits and of the guard
limits.
Allows the accurate control of the various welding
phases (consult the "Guard limits" section).
General
Allows the selection of the required welding method.
Manual welding method
Allows the manual setting and regulation of
each individual welding parameter (MIG/
MAG).
Synergic welding method
Makes it possible to use a series of pre-settings
(synergic curves) available in the memory of the
system.
The changing and correction of the initial set-
tings proposed by the system is allowed.
1
It allows the selection of:
synergic MIG
manual MIG
Select however one of suggested synergies (5-6) in
order to take advantage of ignition potentiality,
closing arc features....
2/3
Lets you select:
- type of filler material
- gas type
4
Lets you select:
- wire diameter
5
- Type of filler material
- Gas type
6 Wire diameter
7 Header
(See the "Main screen" section).
NO PROGRAM
Indicates that the selected synergic program is not avail-
able or is not consistent with the other system settings.