3 SYSTEM PRESENTATION
3.1 General
The Genesis 3000 PMC - Genesis 3000 SMC - Genesis 3000
MTE are constant current inverter power sources developed
for electrode (MMA), TIG DC (direct current), MIG/MAG and
Pulsed MIG welding (MTE/PMC).
They are fully digital multiprocessor systems (data processing on
DSP and communication over CAN-BUS), capable of meeting
the various requirements of the welding world in the best pos-
sible way.
3.2 Front control panel
1
Power supply
Indicates that the equipment is connected to the mains
and is on.
2
General alarm
Indicates the possible intervention of protection devices
such as the temperature protection.
3
Power on
Indicates the presence of voltage on the equipment
outlet connections.
4
7-segment display
Allows the general welding machine parameters to be
displayed during start-up, settings, current and voltage
readings, while welding, and encoding of the alarms.
5
LCD display
Allows the general welding machine parameters to be
displayed during start-up, settings, current and voltage
readings, while welding, and encoding of the alarms.
Allows all the operations to be displayed instantaneously.
6
Main adjustment handle.
Allows entry to set up, the selection and the setting of
the welding parameters.
7
Processes/functions
Let you select the various system functions (welding
process, welding mode, current pulse, graphic mode,
etc.).
8
Synergy
Lets you select a preset welding program (synergy) by
choosing a few simple settings:
- wire type
- gas type
- wire diameter
42
All manuals and user guides at all-guides.com
9
3.3 Starting Screen
When switched on, the generator performs a succession of
checks in order to guarantee the correct operation of the system
and of all the devices connected to it.
At this stage the gas test is also carried out to check the proper
connection to the gas supply system (system for automation and
robotics).
Any lack of gas flow sets off a dedicated audible and visual alarm
signal (consult the "Alarms" section).
3.4 Test screen
When the side panel (coil compartment) is open, the welding
operations are inhibited.
The test screen appears on the LCD display.
1
2
3
4
5
6
7
3.5 Main Screen
Allows the control of the system and of the welding process,
showing the main settings.
MMA
Programs
Allows the storage and management of 64 welding
programs which can be personalised by the operator.
Wire feed
Wire withdrawal (automation and robotics)
Compressed air test (automation and robotics)
Gas test
Wire speed
Allows the regulation of the wire feed rate.
Minimum 1 m/min, Maximum 22 m/min,
Default 1.0m/min
Side panel open
Heading
Allows the display of certain pieces of important infor-
mation relating to the selected process.