Care And Maintenance; Spares And Accessories - Elcometer 116C Guia Del Usuario

5 CARE AND MAINTENANCE

To replace a thermometer - remove the thermometer from the holding
clip. Slot the new thermometer into place and retighten the holding
screws.
Always keep the wick clean and saturated with clean (distilled) water.
To remove dirty wick material cut off the dirty piece of wick and pull
clean wick material from the end cap and over the bulb. Extra wicks
may be stored, loosely packed, in the end cap.

6 SPARES AND ACCESSORIES

The following spares and accessories are compatible with the
Elcometer branded product:
Description
Thermometer °C - Pack of 2
Replacement Wicks - Pack of 4
Spares and accessories for the non Elcometer branded product are
listed below:
Description
Thermometer °C - Pack of 2
Thermometer °F
Replacement Wicks - Pack of 4
For the avoidance of doubt, please refer to the original English language version.
Please ensure that all packaging is disposed of in an environmentally sensitive manner. Consult your local
Environmental Authority for further guidance.
is a registered trademark of Elcometer Limited, Edge Lane, Manchester, M43 6BU. United Kingdom
R
All other trademarks acknowledged.
© Elcometer Limited 2008-2020. All rights reserved. No part of this document may be reproduced, transmitted,
transcribed, stored (in a retrieval system or otherwise) or translated into any language, in any form or by any
means (electronic, mechanical, magnetic, optical, manual or otherwise) without the prior written permission of
Elcometer Limited.
R
Part Number
T11631224
T11631168
Part Number
T11631224
T1164479-
T11631168
TMA-0138 Issue 09 - Text with cover 4801